DB2 Replication Guide and Reference

Starting the Capture and Apply Programs

After defining the source and subscription, you can submit the copy request by starting the Capture and Apply programs.

To start the Capture program from the SAMPLE source server:

Enter the following command from the Windows NT window:
```
ASNCCP SAMPLE
```
No confirmation message appears. The Capture program has successfully started if it is running and no command prompt appears. The Capture program has initialized but does not start capturing changes for the registered source tables until you start the Apply program and it completes its initial full refresh. See the troubleshooting section in your particular platform chapter for problem determination.

To start the Apply program:

Enter the following command from another Windows NT window:
```
ASNAPPLY DEPTQUAL COPYDB
```
No confirmation message appears. The Apply program has successfully started if the program is running and no command prompt appears. You can also check the ASN.IBMSNAP_APPLYTRAIL table for status information. See the troubleshooting section in your particular platform chapter for problem determination.

[ Top of Page | Previous Page | Next Page | Table of Contents | Index ]